Products
Wound paste
I. Product name:
Wound paste
II. Specification:
70mm×18mm; 70mm×22mm; 76mm×38mm; 75mm×20mm; 60mm×80mm; 90mm×100mm; 80mm×110mm; 90mm×150mm; 90mm×200mm; 90mm×250mm; 90mm×350mm; 140mm×160mm。
Note: Special specification can be produced according to the contract.
III. Type:
Nanometer carbon fiber wound paste, cartoon wound paste, nanometer wound paste, waterproof wound paste, elastic skin color wound paste, skin color wound paste.
IV. Basic structure:
Wound paste is composed of PVC or PE or PU or PET or medical adhesive plaster, absorbent pad, release paper and PVC film.
V. Main performance index:
1. The adhesive tape is in compliance with YY/T 0148—2006 medical adhesive tape requirements;
2. Absorbent pad capacity:
1) The absorbent pad capacity in carbon fiber wound paste should not be lower than 10g;
2) The absorbent pad capacity in General wound paste should not be lower than 1g.
3. In compliance with GB/T16886.1-2011 standard.
VI. Application range:
For skin surface absorption dressing.
VII. Use:
1. Clean the wound before use.
VIII. Contraindications:
1. No adverse effect generally, it is contraindicated in patients with zinc oxide allergy.
2. The adhesive type cannot paste on the wound directly.
IX. Sterilization method:
It is sterilized with ethylene oxide (the effective period refers to the packing box).
X. Precaution and warm:
1. Forbid to use if the package is damaged;
2. Forbid to use in case of exceed effective period.
3. No adverse effect generally, it is contraindicated in patients with skin allergy.
4. The adhesive type cannot paste on the wound directly.
XI. Storage & transportation:
It should be stored in clean and ventilated room, where the relative humidity should be lower than 80% and free of corrosive gas, avoid direct sun light.
XII. Shelf life:
It is available for 2 years.
XIII. Symbolic interpretation:
Attention, refer to the attached document 
The products can not be used 
It is sterilized with ethylene oxide